Search results
Results from the WOW.Com Content Network
Proto Tools (formally Stanley Proto) is an American industrial hand tool company. Founded as Plomb , it is presently a division of Stanley Black & Decker . The company is credited with creating the first combination wrench in 1933.
A key component of modern torque testers is the digital display. A digital display is used to measure the output signal from the transducer and calculates that reading into a torque value that is displayed on screen. In most cases the display and transducer are contained together inside a housing. This is known as a "Desktop Torque Tester".
Prony brake dynamometers at a tractor contest in 1910 Schematic of a Prony brake Actual Prony Brake built for testing 5HP Steam Engine. The Prony brake is a simple device invented by Gaspard de Prony in 1821 to measure the torque produced by an engine. The term "brake horsepower" is one measurement of power derived from this method of measuring ...
A click torque wrench. A torque wrench is a tool used to apply a specific torque to a fastener such as a nut, bolt, or lag screw.It is usually in the form of a socket wrench with an indicating scale, or an internal mechanism which will indicate (as by 'clicking', a specific movement of the tool handle in relation to the tool head) when a specified (adjustable) torque value has been reached ...
Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors.This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.
The cap torque tester is used in the packaging industry to measure the opening or closing torque of the screw cap. Proper torque is required for the cap to perform its functions of maintaining a tight seal. [1] It is a piece of specific quality control equipment that can be placed on the production line or in the laboratory. Several designs ...
The torque limiting clutch is the part of the tool that limits the amount of torque being applied to the fastener at the receiving end of the tool. On simpler tools the clutch settings may be marked with arbitrary numbers (e.g., from 1 for the lowest available torque to 20 for the highest, without necessarily having a linear relationship with ...
The test may still be conducted at full voltage if it is brief enough to avoid overheating the windings or overloading the starting circuits, but requires much more care to be taken while performing the test. [4] The blocked rotor torque test is less significant on wound-rotor motors because the starting torque of these wound-rotor motors ...