Search results
Results from the WOW.Com Content Network
The bipolar junction transistor, the first type of transistor to be mass-produced, is a combination of two junction diodes and is formed of either a thin layer of p-type semiconductor sandwiched between two n-type semiconductors (an n–p–n transistor), or a thin layer of n-type semiconductor sandwiched between two p-type semiconductors (a p ...
The common base current gain (or α) of a point-contact transistor is usually around 2 to 3, [4] whereas α of bipolar junction transistor (BJT) cannot exceed 1. The common emitter current gain (or β) of a point-contact transistor does not usually exceed 1, [4] whereas β of a BJT is typically between 20 and 200. Negative differential ...
First edition. Electrons and Holes in Semiconductors with Applications to Transistor Electronics is a book by Nobel Prize winner William Shockley, [1] first published in 1950. . It was a primary source, and was used as the first textbook, for scientists and engineers learning the new field of semiconductors as applied to the development of the transis
Bipolar transistors, and particularly power transistors, have long base-storage times when they are driven into saturation; the base storage limits turn-off time in switching applications. A Baker clamp can prevent the transistor from heavily saturating, which reduces the amount of charge stored in the base and thus improves switching time.
The width and thickness of the interconnect, as well as the material from which it is made, are some of the significant factors that determine the distance a signal may propagate. Local interconnects connect circuit elements that are very close together, such as transistors separated by ten or so other contiguously laid out transistors.
Schematic diagram of a single-electron transistor Left to right: energy levels of source, island and drain in a single-electron transistor for the blocking state (upper part) and transmitting state (lower part). The SET has, like the FET, three electrodes: source, drain, and a gate. The main technological difference between the transistor types ...
The original unijunction transistor, or UJT, is a simple device that is essentially a bar of n-type semiconductor material into which p-type material has been diffused somewhere along its length, fixing the device parameter (the "intrinsic stand-off ratio"). The 2N2646 model is the most commonly used version of the UJT.
A translinear circuit is a circuit that carries out its function using the translinear principle. These are current-mode circuits that can be made using transistors that obey an exponential current-voltage characteristic—this includes bipolar junction transistors (BJTs) and CMOS transistors in weak inversion.