enow.com Web Search

  1. Ads

    related to: is 98% humidity high in basement area for water leak repair

Search results

  1. Results from the WOW.Com Content Network
  2. Basement waterproofing - Wikipedia

    en.wikipedia.org/wiki/Basement_waterproofing

    The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the basement. The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high ...

  3. Indoor mold - Wikipedia

    en.wikipedia.org/wiki/Indoor_mold

    The area should be surveyed for odors indicating mold or bacterial growth, moisture sources, such as stagnant water or leaking pipes, and water-damaged building materials. [15] This can include moving furniture , lifting (or removing) carpets, checking behind wallpaper or paneling, checking ventilation ductwork and exposing wall cavities.

  4. Basement - Wikipedia

    en.wikipedia.org/wiki/Basement

    It is virtually impossible to make a concrete wall waterproof, over the long run, so drainage is the key. There are draining membranes that can be applied to the outside of the basement that create channels for water against the basement wall to flow to the foundation drains. [16] Where drainage is inadequate, waterproofing may be needed.

  5. Humidity - Wikipedia

    en.wikipedia.org/wiki/Humidity

    In a scientific notion, the relative humidity (or ) of an air-water mixture is defined as the ratio of the partial pressure of water vapor in air to the saturation vapor pressure of water at the same temperature, usually expressed as a percentage: [11] [12] [5] = % /

  6. Indoor air quality - Wikipedia

    en.wikipedia.org/wiki/Indoor_air_quality

    [citation needed] However, high humidity outdoors creates the need for careful attention to humidity levels indoors. High humidity give rise to mold growth and moisture indoors is associated with a higher prevalence of occupant respiratory problems. [citation needed] The "dew point temperature" is an absolute measure of the moisture in air ...

  7. Fallingwater - Wikipedia

    en.wikipedia.org/wiki/Fallingwater

    [234] [235] Even though most of the leaks had been repaired, rain and snow still pooled on the terraces and roof, [236] [234] and water came in through the walls. [229] In addition, the ends of the terraces had sagged by 7 inches (180 mm), [ 7 ] [ 237 ] tilting almost two degrees. [ 179 ]

  8. Monroe County, Pennsylvania - Wikipedia

    en.wikipedia.org/wiki/Monroe_County,_Pennsylvania

    Although most summer days are slightly humid in the Ridge and Valley, episodes of heat and high humidity can occur with heat index values > 102 °F (39 °C). Since 1981, the highest air temperature was 100.3 °F (37.9 °C) on July 22, 2011, and the highest daily average mean dew point was 72.7 °F (22.6 °C) on January 8, 2006.

  9. Leak-down tester - Wikipedia

    en.wikipedia.org/wiki/Leak-down_tester

    A locomotive engine which gives a leak-down of 10% on a leak-down tester is virtually perfectly sealed while the same tester giving a 10% reading on a model airplane engine indicates a catastrophic leak. With a non-turbulent .040" orifice, and with a cylinder leakage effective orifice size of .040", leakage would be 50% at any pressure.

  1. Ads

    related to: is 98% humidity high in basement area for water leak repair