enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Motorcycle tyre - Wikipedia

   en.wikipedia.org/wiki/Motorcycle_tyre

   A motorcycle tyre (spelt tire in American English) is the outer part of motorcycle wheel, attached to the rim, providing traction, resisting wear, absorbing surface irregularities, and allowing the motorcycle to turn via countersteering. The two tyres' contact patches are the motorcycle's connection to the ground, and so are fundamental to the ...

3. Bicycle and motorcycle dynamics - Wikipedia

   en.wikipedia.org/wiki/Bicycle_and_motorcycle...

   For example, a motorcycle with a 12 inch wide rear tire will have t = 6 inches. If the combined bike and rider center of mass is at a height of 26 inches, then a 25° lean must be increased by 7.28°: a nearly 30% increase. If the tires are only 6 inches wide, then the lean angle increase is only 3.16°, just under half.

4. Contact patch - Wikipedia

   en.wikipedia.org/wiki/Contact_patch

   Contact patch. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface. It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire’s tread that touches the road surface. The term “footprint” is used almost ...

5. Ground pressure - Wikipedia

   en.wikipedia.org/wiki/Ground_pressure

   Ground pressure is the pressure exerted on the ground by the tires or tracks of a motorized vehicle, and is one measure of its potential mobility, [1] especially over soft ground. It also applies to the feet of a walking person or machine. Pressure is measured in the SI unit of pascals (Pa). Average ground pressure can be calculated using the ...

6. ISO 5775 - Wikipedia

   en.wikipedia.org/wiki/ISO_5775

   ISO 5775. ISO 5775 is an international standard for labeling the size of bicycle tires and rims. The system used was originally developed by the European Tyre and Rim Technical Organisation (ETRTO). It is designed to make tire sizing consistent and clear. It replaces overlapping informal systems that ambiguously distinguished between sizes.

7. Tire code - Wikipedia

   en.wikipedia.org/wiki/Tire_code

   Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [34] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.