enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Lathe faceplate - Wikipedia

   en.wikipedia.org/wiki/Lathe_faceplate

   Unusual slotted faceplate. A lathe faceplate is a basic workholding accessory for a wood or metal turning lathe. It is a circular metal (usually cast iron) plate which fixes to the end of the lathe spindle. The workpiece is then clamped to the faceplate, typically using t-slot nuts in slots in the faceplate, or less commonly threaded holes in ...

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A chuck is a specialized type of clamp used to hold an object with radial symmetry, especially a cylinder. In a drill, a mill and a transmission, a chuck holds the rotating tool; in a lathe, it holds the rotating workpiece. [1] Chucks commonly use jaws to hold the tool or workpiece. The jaws (sometimes called dogs) are typically arranged in a ...

4. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Drill chucks mounted by Jacobs tapers onto arbors with Morse tapers for the spindle. Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut.

5. Spindle turning - Wikipedia

   en.wikipedia.org/wiki/Spindle_turning

   For spindle turning, the wood is held on the lathe either by both ends (between the headstock and tailstock) or by one end only using a lathe chuck [2]. Wood is generally removed by running a turning tool down the slope of the wood from a larger diameter in the wood to a smaller diameter.

6. Lathe - Wikipedia

   en.wikipedia.org/wiki/Lathe

   Modern metal lathe A watchmaker using a lathe to prepare a component cut from copper for a watch. A lathe (/ l eɪ ð /) is a machine tool that rotates a workpiece about an axis of rotation to perform various operations such as cutting, sanding, knurling, drilling, deformation, facing, threading and turning, with tools that are applied to the workpiece to create an object with symmetry about ...

7. Lathe center - Wikipedia

   en.wikipedia.org/wiki/Lathe_center

   Lathe center. Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis. They usually have an included angle of 60°, but in heavy ...