Search results
Results from the WOW.Com Content Network
In computing, POST is a request method supported by HTTP used by the World Wide Web. By design, the POST request method requests that a web server accepts the data enclosed in the body of the request message, most likely for storing it. [1] It is often used when uploading a file or when submitting a completed web form.
The request/response message consists of the following: Request line, such as GET /logo.gif HTTP/1.1 or Status line, such as HTTP/1.1 200 OK, Headers; An empty line; Optional HTTP message body data; The request/status line and headers must all end with <CR><LF> (that is, a carriage return followed by a line feed).
A client request (consisting in this case of the request line and a few headers that can be reduced to only the "Host: hostname" header) is followed by a blank line, so that the request ends with a double end of line, each in the form of a carriage return followed by a line feed.
The length of the request body in octets (8-bit bytes). Content-Length: 348: Permanent RFC 9110: Content-MD5: A Base64-encoded binary MD5 sum of the content of the request body. Content-MD5: Q2hlY2sgSW50ZWdyaXR5IQ== Obsolete [15] RFC 1544, 1864, 4021: Content-Type: The Media type of the body of the request (used with POST and PUT requests).
As of 21 January 2025 (two months after PHP 8.4's release), PHP is used as the server-side programming language on 75.0% of websites where the language could be determined; PHP 7 is the most used version of the language with 47.1% of websites using PHP being on that version, while 40.6% use PHP 8, 12.2% use PHP 5 and 0.1% use PHP 4.
Diagram of a double POST problem encountered in user agents. Diagram of the double POST problem above being solved by PRG. Post/Redirect/Get (PRG) is a web development design pattern that lets the page shown after a form submission be reloaded, shared, or bookmarked without ill effects, such as submitting the form another time.
[7] [a] On February 25, 2008, the W3C published the Working Draft Level 2 specification. [8] Level 2 added methods to monitor event progress, allow cross-site requests, and handle byte streams. At the end of 2011, the Level 2 specification was absorbed into the original specification. [9]
The PATCH request needs to use mechanisms such as conditional requests using Etags and the If-Match request header to ensure that data is not corrupted while patching. [1] In case of a failure of a PATCH request or failure of the channel or a timeout, the client can use a GET request to check the state of the resource. [ 1 ]