Search results
Results from the WOW.Com Content Network
LNA-100 Boost Antenna Amplifier. If you’re looking for an antenna amplifier that's easy to set up and minimizes wires in your house, the Winegard LNA-100 Boost is an ideal choice.
The audio signal goes to a 4.5 MHz amplifier. This amplifier prepares the signal for the 4.5 MHz detector. It then goes through a 4.5 MHz IF transformer to the detector. In television, there are 2 ways of detecting FM signals. One way is by the ratio detector. This is simple but very hard to align. The next is a relatively simple detector.
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .
In this circuit, the base terminal of the transistor serves as the input, the collector is the output, and the emitter is common to both (for example, it may be tied to ground reference or a power supply rail), hence its name. The analogous FET circuit is the common-source amplifier, and the analogous tube circuit is the common-cathode amplifier.
Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator.. Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.
IF amplifiers in heterodyne receivers apply gain in a frequency band between the input radio frequency and output audio frequency or video frequency, often following one stage of RF amplifier. This allows most of the gain in the form of a fixed-frequency amplifier, simplifying tuning. Compare to its predecessor, the tuned RF receiver.
Even after the introduction of printed circuit boards, it did not require laying out and manufacturing circuit boards. Point-to-point and terminal strip construction continued to be used for some vacuum tube equipment even after the introduction of printed circuit boards. The heat of the tubes can degrade the circuit boards and cause them to ...
6N3C power tube. A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal.Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.