Search results
Results from the WOW.Com Content Network
The numbers that may be represented in the decimal system are the decimal fractions. That is, fractions of the form a/10 n, where a is an integer, and n is a non-negative integer. Decimal fractions also result from the addition of an integer and a fractional part; the resulting sum sometimes is called a fractional number.
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
Decimal fractions are commonly expressed using decimal notation in which the implied denominator is determined by the number of digits to the right of a decimal separator, the appearance of which (e.g., a period, an interpunct (·), a comma) depends on the locale (for examples, see Decimal separator). Thus, for 0.75 the numerator is 75 and the ...
3 mm scale, also known as 3 mm finescale, is a model railway scale of 3 mm : 1 ft (305 mm) used for British prototypes. Introduced as British TT gauge , it sits approximately halfway between British N gauge and OO gauge but is not as popular as either and there is no longer any mass manufacturer ready-to-run support.
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
For a positive number written in a conventional positional numeral system (such as binary or decimal), its fractional part hence corresponds to the digits appearing after the radix point, such as the decimal point in English. The result is a real number in the half-open interval [0, 1).