enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dana 30 - Wikipedia

   en.wikipedia.org/wiki/Dana_30

   The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30

3. Jeep Cherokee (XJ) - Wikipedia

   en.wikipedia.org/wiki/Jeep_Cherokee_(XJ)

   Jeep simply used a single axle tube from hub to hub with no differential between, resulting in an inexpensive front suspension. For 1996, partially to comply with new U.S. OBD-II exhaust and evaporative emissions regulations, the engine management system was upgraded to Chrysler's then-new "JTEC" PCM.

4. Chevrolet S-10 Blazer - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_S-10_Blazer

   It also lifted the Blazer about three inches higher, allowing it to clear 31×10.5" tires on 15-inch wheels. Enhanced front (7.25" ring gear) and rear (8.5" ring gear) axles with a 3.73:1 rear-axle ratio, larger wheels and axle bearings, a stronger front anti-sway bar, skid plates, and Bilstein shocks were also added.

5. Chevrolet small-block engine (first- and second-generation)

   en.wikipedia.org/wiki/Chevrolet_small-block...

   The 267 was introduced in 1979 for the GM F-body (Camaro), G-body (Chevrolet Monte Carlo, El Camino), A-body (Malibu Classic, 1979–1981) and also used on GM B-body cars (Impala and Caprice models). The 4.4 L; 267.8 cu in (4,389 cc) engine had the 350's crankshaft stroke of 3.48 in (88.4 mm) and the smallest bore of any small-block, 3.5 in (88 ...

6. Plymouth Duster - Wikipedia

   en.wikipedia.org/wiki/Plymouth_Duster

   Disc brake-equipped Dusters now had the more-common 5-lugs on a 4.5-inch wheel bolt pattern. All 340 and some 318 engine-equipped cars received the simplified 8.25-inch rear axle assembly (with wheel bearings riding directly on the axle shaft and endplay being taken by C-clips); these axles also featured the 5 on a 4.5-inch wheel bolt pattern.

7. Iron Duke engine - Wikipedia

   en.wikipedia.org/wiki/Iron_Duke_engine

   For 1980 the Iron Duke engine was redesigned to be mounted transversely, to suit the new front-drive General Motors "X-body" cars. The bellhousing bolt pattern was revised to match that of the new 60° V6 engine. 1982 AMC Spirit with Iron Duke. GM also began selling the engine to American Motors Corporation (AMC