Search results
Results from the WOW.Com Content Network
Dual-ported RAM (DPRAM), also called dual-port RAM, is a type of random-access memory (RAM) that can be accessed via two different buses.. A simple dual-port RAM may allow only read access through one of the ports and write access through the other, in which case the same memory location cannot be accessed simultaneously through the ports since a write operation modifies the data and therefore ...
Dual-ported video RAM (VRAM) is a dual-ported RAM variant of dynamic RAM (DRAM), which was once commonly used to store the Framebuffer in Graphics card, . Dual-ported RAM allows the CPU to read and write data to memory as if it were a conventional DRAM chip, while adding a second port that reads out data.
In the late 1980s IBM invented DDR SDRAM, they built a dual-edge clocking RAM and presented their results at the International Solid-State Circuits Convention in 1990. [ 6 ] [ 7 ] Samsung released the first commercial DDR SDRAM chip (64 Mbit ) in June 1998, [ 3 ] followed soon after by Hyundai Electronics (now SK Hynix ) the same year. [ 8 ]
Dual-channel memory slots, color-coded orange and yellow for this particular motherboard. Dual-channel-enabled memory controllers in a PC system architecture use two 64-bit data channels. Dual-channel should not be confused with double data rate (DDR), in which data exchange happens twice per DRAM clock. The two technologies are independent of ...
A block diagram is a diagram of a system in which the principal parts or functions are represented by blocks connected by lines that show the relationships of the blocks. [1] They are heavily used in engineering in hardware design , electronic design , software design , and process flow diagrams .
Memory geometry describes the logical configuration of a RAM module, but consumers will always find it easiest to grasp the physical configuration. Much of the confusion surrounding memory geometry occurs when the physical configuration obfuscates the logical configuration. The first defining feature of RAM is form factor.
It adds functions such as bit masking (writing to a specified bit plane without affecting the others) and block write (filling a block of memory with a single colour). Unlike VRAM and WRAM, SGRAM is single-ported. However, it can open two memory pages at once, which simulates the dual-port nature of other video RAM technologies.
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.