Search results
Results from the WOW.Com Content Network
The above code defines the basic 2×2 brick. It consists of a five-sided box (box5.dat, outside) and an inverted five-sided box (inside), the connection between those two, consisting of four quads (the four lines starting with 4), the four studs on top of it (stud.dat) and the long hollow stud in the inside (stud4.dat).
ISO 2848:1984, published by International Organization for Standardization, is an ISO standard used by the construction industry. [1]Adherence to the standard means that major dimensions such as grid lines on drawings, distances between wall centres or surfaces, widths of shelves and kitchen components are multiples of the basic module.
In construction, a dwang (Scotland and New Zealand), [1] [2] [3] nogging piece, nogging, noggin or nog (England and Australia; all derived from brick nog), [4] [5] or blocking (North America), is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
Exterior wall studs are the vertical members to which the wall sheathing and cladding are attached. [14] They are supported on a bottom plate or foundation sill and in turn support the top plate. Studs usually consist of 1 + 1 ⁄ 2 -by- 3 + 1 ⁄ 2 -inch (38 mm × 89 mm) or 1 + 1 ⁄ 2 -by- 5 + 1 ⁄ 2 -inch (38 mm × 140 mm) lumber and are ...
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]
Lower wall plates, base plate, floor plate, or bottom plate [4] — a second lower wall plate to which the wall studs are through nailed and which is the bottom of the wall section when assembled as a rectangular assembly. On an upper story, the lower wall plate is nailed to the platform of the supporting floor. The supporting platform is being ...