Search results
Results from the WOW.Com Content Network
MDF is typically made up of 82% wood fibre, 9% urea-formaldehyde resin glue, 8% water, and 1% paraffin wax. [4] The density is typically between 500 and 1,000 kg/m 3 (31 and 62 lb/cu ft). [ 5 ] The range of density and classification as light-, standard-, or high-density board is a misnomer and confusing.
Typical R-values are given for various materials and structures as approximations based on the average of available figures and are sorted by lowest value. R-value at 1 m gives R-values normalised to a 1 metre (3 ft 3 in) thickness and sorts by median value of the range.
Closed-cell foams are superior insulators. While open-cell foams typically have R-values of 3 to 4 per inch (RSI-0.53 to RSI-0.70 per inch), closed-cell foams can attain R-values of 5 to 8 per inch (RSI-0.88 to RSI-1.41 per inch). This is important if space is limited, because it allows a thinner layer of insulation to be used.
The R-value is the building industry term [3] for thermal resistance "per unit area." [4] It is sometimes denoted RSI-value if the SI units are used. [5] An R-value can be given for a material (e.g., for polyethylene foam), or for an assembly of materials (e.g., a wall or a window). In the case of materials, it is often expressed in terms of R ...
Fiberboard (American English) or fibreboard (British English) is a type of engineered wood product that is made out of wood fibers. Types of fiberboard (in order of increasing density) include particle board or low-density fiberboard (LDF), medium-density fiberboard (MDF), and hardboard or high-density fiberboard (HDF).
The R-value of 3.6 to 3.8 per inch [citation needed] is good but not the best. [citation needed] Material cost per R-value is good but labor cost goes up because it takes more material and time to install than fiberglass insulation at the same R-Value [citation needed].
The natural deduction is that wood of first-class mechanical value shows from 5 to 20 rings per inch (rings 1.3–5 mm thick) and that slower growth yields poorer stock. Thus the inspector or buyer of hickory should discriminate against timber that has more than 20 rings per inch (rings less than 1.3 mm thick).
Hardboard is similar to particle board and medium-density fiberboard, but is denser, stronger and harder because it is made out of exploded wood fibers that have been highly compressed. [ 3 ] The density of hardboard is higher than 500 kg/m 3 (31 lb/cu ft), [ 4 ] usually about 800–1,040 kg/m 3 (50–65 lb/cu ft). [ 5 ]