Search results
Results from the WOW.Com Content Network
Bottled water dispensers can be top-mounted or bottom-loaded, depending on the design of the model. Bottled water dispensers typically use 11- or 22-liter (5- or 10-gallon) dispensers commonly found on top of the unit. Pressure coolers are a subcategory of water dispensers encompassing drinking water fountains and direct-piping water dispensers.
Refillable bottle with pump dispenser for liquid soap. A pump dispenser is used on containers of liquids to help dispensing. They might be used on bottles, jars, or tubes. Often the contents are viscous liquids such as creams and lotions. [1] Some are metered to provide uniform usage.
Hot water dispenser at Lanzhou Bus Station, China, providing free boiling water to make a cup of tea or a bowl of instant noodles. An instant hot water dispenser or boiling water tap is an appliance that dispenses water at about 94 °C (201 °F) (near-boiling). There are hot-only and hot and cool water models, and the water may be filtered as ...
An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.
A media dispenser or a culture media dispenser is a device for repeatedly delivering small fixed volumes (typically between 1 ml and 50 ml) of liquid such as a laboratory growth medium like molten agar or caustic or volatile solvents like toluene into a series of receptacles (Petri dishes, test tubes, Fernbach flasks, etc.).
Force pump. In a lift pump, the upstroke of the piston draws water, through a valve, into the lower part of the cylinder. On the downstroke, water passes through valves set in the piston into the upper part of the cylinder. On the next upstroke, water is discharged from the upper part of the cylinder via a spout.
Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...
The water ladder was built as an alternative to the paddle wheel to get around the problem that to lift water to a greater height, a bigger wheel is needed. [1] Despite the emergence of new pumps that operate on other principles, the water ladder remains an important tool as some of its other benefits are that they can be built and repaired easily at a very low cost.