Search results
Results from the WOW.Com Content Network
1.5 psi Pressure increase per meter of a water column [26] 10 kPa 1.5 psi Decrease in air pressure when going from Earth sea level to 1000 m elevation [citation needed] +13 kPa +1.9 psi High air pressure for human lung, measured for trumpet player making staccato high notes [48] < +16 kPa +2.3 psi
Using the figures above, we can calculate the maximum pressure at various depths in an offshore oil well. Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal)
In 1824, these units were replaced with a single system based on the imperial gallon. [a] Originally defined as the volume of 10 pounds (4.54 kg) of distilled water (under certain conditions), [b] then redefined by the Weights and Measures Act 1985 to be exactly 4.546 09 L (277.4 cu in), the imperial gallon is close in size to the old ale gallon.
The kilopound per square inch (ksi) is a scaled unit derived from psi, equivalent to a thousand psi (1000 lbf/in 2). ksi are not widely used for gas pressures. They are mostly used in materials science, where the tensile strength of a material is measured as a large number of psi. [4] The conversion in SI units is 1 ksi = 6.895 MPa, or 1 MPa ...
The energy content of ethanol is 76,100 BTU/US gal (5.89 kilowatt-hours per litre), compared to 114,100 BTU/US gal (8.83 kWh/L) for gasoline. (see chart above) A flex-fuel vehicle will experience about 76% of the fuel mileage MPG when using E85 (85% ethanol) products as compared to 100% gasoline.
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
In US customary units, most units of volume exist both in a dry and a liquid version, with the same name, but different values: the dry hogshead, dry barrel, dry gallon, dry quart, dry pint, etc. The bushel and the peck are only used for dry goods. Imperial units of volume are the same for both dry and liquid goods. They have a different value ...