Search results
Results from the WOW.Com Content Network
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
The Standard Disk Interconnect (SDI, sometimes Standard Disk Interface) was used by Digital Equipment Corporation for its line of RAxx disks, for example the RA90. There were two bi-directional serial communications paths between the controller and the drive. One path was for messages (from the controller to the drive) and responses (from the ...
Using a standard SDI transport, the extra data is placed within normal active video, between Start of Active Video (SAV), and End of Active Video (EAV). This gives 1440 10-bit words of data at 270 Mbit/s (1920 words in the 8bit 360 Mbit/s standard).
Level B-DS format is the dual-stream carriage of two independent HD-SDI/SMPTE 292M signals (720p up to 60 fps or 1080i/1080p up to 30 fps) in a single serial digital interface at the nominal 3 Gbit/s. That is, two video signals, two video streams, in one cable. [3]
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.
Microsoft provides a tool called the "SDI File Manager" (sdimgr.exe) which can be used for the purpose of manipulating SDI files. Some of the tasks which this tool facilitates are: The creation of an SDI image file. The creation of an SDI image file from an existing hard disk partition. The verification of an existing SDI image.
A keystone module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks or optical connectors into a keystone wall plate, face plate, surface-mount box, or a patch panel. Keystone modules have a rectangular face of 14.5 mm wide by 16.0 mm high and are held in place with flexible tabs.
The Flat Display Mounting Interface (FDMI), also known as VESA Mounting Interface Standard (MIS) or colloquially as VESA mount, is a family of standards defined by the Video Electronics Standards Association for mounting flat panel monitors, televisions, and other displays to stands or wall mounts. [1]