enow.com Web Search

  1. Ad

    related to: bullnose drywall corners vs square wall

Search results

  1. Results from the WOW.Com Content Network
  2. Bullnose - Wikipedia

    en.wikipedia.org/wiki/Bullnose

    Bullnose trim is used to provide a smooth, rounded edge for countertops, staircase steps, building corners, verandas, or other construction.Masonry units such as bricks, concrete masonry units or structural glazed facing tiles may be ordered from manufacturers with square or bullnosed corners.

  3. Shoulder plane - Wikipedia

    en.wikipedia.org/wiki/Shoulder_plane

    It is used when it is necessary to trim right into the concave corner where two surfaces of the same piece of wood meet perpendicularly. It is also commonly used to clean up dadoes (housings) and tenons for joinery. Unlike the rebate plane, the shoulder plane is intended to cut end grain. There are therefore differences between it and a rebate ...

  4. Glossary of British bricklaying - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_British...

    Honeycomb wall: A wall, usually stretcher bond, in which the vertical joints are opened up to the size of a quarter bat to allow air to circulate. Commonly used in sleeper walls. Indent: A hole left in a wall in order to accommodate an adjoining wall at a future date. These are often left to permit temporary access to the work area.

  5. Drywall - Wikipedia

    en.wikipedia.org/wiki/Drywall

    Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...

  6. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

  7. Rebate plane - Wikipedia

    en.wikipedia.org/wiki/Rebate_plane

    The rebate plane commonly has a depth stop and a fence, which allows the width and depth of the rabbet to be gauged. They also are commonly equipped with a spur, which is designed to score the wood as the rabbet is cut, giving a cleaner corner. This is particularly valuable when working across the grain. [1]

  8. Plasterwork - Wikipedia

    en.wikipedia.org/wiki/Plasterwork

    At the place where the two edges of wallboards meet there is a seam. These seams are covered with mesh tape and then the seams and the screw heads are concealed with the drywall compound to make the wall seem as one uniform piece. The drywall plaster is a thick paste. Later this is painted or wallpapered over to hide the work.

  9. Rustication (architecture) - Wikipedia

    en.wikipedia.org/wiki/Rustication_(architecture)

    Rustication therefore often reverses the patterns of medieval and later vernacular architecture, where roughly dressed wall surfaces often contrast with ashlar quoins and frames to openings. Regular smooth-faced rustication (left) turns to horizontal banded rustication at the corner of Castle Howard in North Yorkshire, England.

  1. Ad

    related to: bullnose drywall corners vs square wall