Search results
Results from the WOW.Com Content Network
The most common flare fitting standards in use today are the 45° SAE flare [2] [3],the 37° JIC flare, and the 37° AN flare. For high pressure, flare joints are made by doubling the tube wall material over itself before the bell end is formed. The double flare avoids stretching the cut end where a single flare may crack.
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.
A 37° flare type end fitting for flexible hose. The AN thread (also A-N) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid.
AS/NZS 3112 compliant plugs have two flat pins forming an inverted V-shape plus a vertical earthing pin. The flat blades measure 6.35 by 1.6 mm (1 ⁄ 4 by 1 ⁄ 16 in) with the active (line) and neutral pins 17.35 mm (11 ⁄ 16 in) long set 30° to the vertical and the vertical earth pin being 20 mm (0.787 in) in length. [15]
Socket for the tilted flattened pins and half-round earth pin of a Danish computer plug. Since 1 July 2008, French-style CEE 7/5 sockets may also be installed in Denmark. [27] [28] Since 15 November 2011, CEE 7/3 (Schuko) sockets may be installed as well, [29] but Type K remains by far the most common socket in Danish homes as of January 2024 ...
Phoenix Connector. Euroblock, short for "European-style terminal block", [1] is an extra-low voltage disconnectable (or plugable) connector and terminal block combination commonly used for microphone- and line level-audio signals, and for control signals such as RS-232 or RS-485.
The inverter then changes the DC power to high frequency AC power. Due to the reduction in the number of DC sources employed, the structure becomes more reliable and the output voltage has higher resolution due to an increase in the number of steps so that the reference sinusoidal voltage can be better achieved.
Powell v. The Home Depot USA, Inc., 663 F.3d 1221 (Fed. Cir. 2011), [1] was a decision by the United States Court of Appeals for the Federal Circuit on the issue of patent infringement on a "safe hands" device that Michael Powell, an independent contractor for Home Depot, created in response to injuries to the hands of associates using in-store radial arm saws.