enow.com Web Search

  1. Ads

    related to: outboard shaft lengths and transoms 5 mm x 1223 mm metal wire for sale

Search results

  1. Results from the WOW.Com Content Network
  2. Outboard motor - Wikipedia

    en.wikipedia.org/wiki/Outboard_motor

    Outboard motor shaft lengths are standardized to fit 15-, 20- and 25-inch (38-, 51- and 64-centimeter) transoms. If the shaft is too long it will extend farther into the water than necessary creating drag, which will impair performance and fuel economy. If the shaft is too short, the motor will be prone to ventilation.

  3. Sterndrive - Wikipedia

    en.wikipedia.org/wiki/Sterndrive

    The outdrive resembles the bottom half of an outboard motor and is composed of two sub-units: an upper containing a driveshaft connected through the transom to an engine which transmits power to a 90-degree-angle gearbox; and the lower containing a vertical driveshaft receiving power from the upper unit gearbox, transmitted through another 90 ...

  4. Shaft (mechanical engineering) - Wikipedia

    en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

    25 mm to 60 mm with 5 mm steps; 60 mm to 110 mm with 10 mm steps; 110 mm to 140 mm with 15 mm steps; 140 mm to 500 mm with 20 mm steps; The standard lengths of the shafts are 5 m, 6 m and 7 m. Usually 1m to 5m is used.

  5. Transom (nautical) - Wikipedia

    en.wikipedia.org/wiki/Transom_(nautical)

    Vertical transom and stern of a modern cargo ship. In some boats and ships, a transom is the aft transverse surface of the hull that forms the stern of a vessel. Historically, they are a development from the canoe stern (or "double-ender") wherein which both bow and stern are pointed. Transoms add both strength and width to the stern.

  6. British Seagull - Wikipedia

    en.wikipedia.org/wiki/British_Seagull

    The Model 102 engines were fairly large and featured an integral engine cylinder block and head, with a water-injected exhaust. Some Model 102 outboards had a 13-inch-diameter (330 mm) propeller, gaining the moniker of "The Barge Pusher". In the early 1980s the factory produced a new series of British Seagull outboards, the QB series.

  7. Boat building - Wikipedia

    en.wikipedia.org/wiki/Boat_building

    Formerly made of rope, typically of braided stainless steel wire, occasionally solid metal rod. Stem: a continuation of the keel upwards at the bow where the two sides of the hull meet. Stern: the aftmost part of a boat, often ending in a transom. Stern sheets a flat area or deck, inboard of the transom in a small boat. It may contain hatches ...

  8. Suzuki Marine - Wikipedia

    en.wikipedia.org/wiki/Suzuki_Marine

    In January 1954, the company changed its name to Suzuki Motor Co., Ltd. A year later, the first Suzuki automobile, Suzulight, went on sale. In 1965, the company marketed their first Suzuki outboard motor, D55. [5] When the second outboard motor, DT5, was produced in 1977, the corporation marketed it in the U.S. under the new brand Suzuki Marine.

  9. Outboard Marine Corporation - Wikipedia

    en.wikipedia.org/wiki/Outboard_Marine_Corporation

    Outboard Marine Corporation sometimes referred to as Outboard Motor Company was formed in 1929 when ELTO was merged with Lockwood-Ash Motor Company. They began using the name OMC in 1956. Outboard Marine Corporation was the world's largest manufacturer and supplier of outboard motors and second largest producer of powerboats.

  1. Ads

    related to: outboard shaft lengths and transoms 5 mm x 1223 mm metal wire for sale
  1. Related searches outboard shaft lengths and transoms 5 mm x 1223 mm metal wire for sale

    outboard shaft lengths and transoms 5 mm x 1223 mm metal wire for sale near