Search results
Results from the WOW.Com Content Network
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
Building a palisade wall for the fort at Jamestown, Virginia The Golden Plow Tavern in York, PA, is a very unusual American building. It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
A bridge on the Lancaster Canal, featuring coping stones linked by large metal "staples".. Coping (from cope, Latin capa) is the capping or covering of a wall. [1] A splayed or wedge coping is one that slopes in a single direction; a saddle coping slopes to either side of a central high point.
The shingle edges are then cut with another circular saw called a "trim saw" to remove irregular edges. The result is a tapered shingle sawn on all six sides. The thickness of the butt, or thicker end of the tapered cut, is usually 3 ⁄ 8 inch (9.5 mm) thick but is also commonly made to be 5 ⁄ 8 inch (16 mm), and can be made to any custom ...
In architecture or structural engineering, a girt, also known as a sheeting rail, is a horizontal structural member in a framed wall. Girts provide lateral support to the wall panel, primarily to resist wind loads. [citation needed] A comparable element in roof construction is a purlin.
Panel pin; Gutter spike – Large long nail intended to hold wooden gutters and some metal gutters in place at the bottom edge of a roof; Ring (annular, improved, jagged) shank nail – nails that have ridges circling the shank to provide extra resistance to pulling out
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists.