enow.com Web Search

  1. Ads

    related to: diameter of 1 2 bolt to metric bolt

Search results

  1. Results from the WOW.Com Content Network
  2. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

  3. ASTM A325 - Wikipedia

    en.wikipedia.org/wiki/ASTM_A325

    It defines mechanical properties for bolts that range from 12 to 1 + 12 inches (13 to 38 mm) in diameter. [1] The equivalent metric standard is ASTM A325M, which is titled Standard Specification for Structural Bolts, Steel, Heat Treated 830 MPa Minimum Tensile Strength. It defines mechanical properties for sizes M12–36. [2]

  4. Preferred metric sizes - Wikipedia

    en.wikipedia.org/wiki/Preferred_metric_sizes

    Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including:

  5. Bolt (fastener) - Wikipedia

    en.wikipedia.org/wiki/Bolt_(fastener)

    Bolt with a nut. A bolt is an ... ASTM A325, standard for bolts 12 to 1 + 12 inches (12.7 to 38.1 mm) in diameter; ISO 898, standard for metric bolts;

  6. Screw thread - Wikipedia

    en.wikipedia.org/wiki/Screw_thread

    The common V-thread standards (ISO 261 and Unified Thread Standard) include a coarse pitch and a fine pitch for each major diameter. For example, 12-13 belongs to the UNC series (Unified National Coarse) and 12-20 belongs to the UNF series (Unified National Fine). Similarly, M10 (10 mm nominal outer diameter) as per ISO 261 has a ...

  7. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    The major diameter may be slightly different from the shank diameter, which is the diameter of the unthreaded part of the screw. The diameters are sometimes given approximately in fractions of an inch (e.g. the major diameter of a #6 screw is 0.1380 in, approximately 9 ⁄ 64 in = 0.140625 in.

  8. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    An ASME B18.2.1 compliant cap screw has somewhat tighter tolerances than a hex bolt for the head height and the shank length. The nature of the tolerance difference allows an ASME B18.2.1 hex cap screw to always fit where a hex bolt is installed but a hex bolt could be slightly too large to be used where a hex cap screw is designed in.

  9. ISO 898 - Wikipedia

    en.wikipedia.org/wiki/ISO_898

    This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1. Bolts, screws and studs with specified property classes – Coarse thread and fine pitch thread [2] 2. Nuts with specified proof load values – Coarse ...

  1. Ads

    related to: diameter of 1 2 bolt to metric bolt