Search results
Results from the WOW.Com Content Network
Convert mmHg to SI units as follows: 1 mmHg = 0.133 32 kPa. Hence the normal blood pressure in SI units is less than 16.0 kPa SBP and less than 10.7 kPa DBP. These values are similar to the pressure of water column of average human height; so pressure has to be measured on arm roughly at the level of the heart.
The mean effective pressure ... Race car engine (NA Formula 1) 1.6 MPa (232.1 lbf/in 2) Passenger car engine (naturally aspirated Otto) 1.3 MPa (188.5 lbf/in 2)
An example of this is the air pressure in an automobile tire, which might be said to be "220 kPa (32 psi)", but is actually 220 kPa (32 psi) above atmospheric pressure. Since atmospheric pressure at sea level is about 100 kPa (14.7 psi), the absolute pressure in the tire is therefore about 320 kPa (46 psi).
Pressure is an expression of the force required to stop a fluid from expanding, and is usually stated in terms of force per unit area. A pressure sensor usually acts as a transducer; it generates a signal as a function of the pressure imposed. Pressure sensors can vary drastically in technology, design, performance, application suitability and ...
The ground pressure of motorized vehicles is often compared with the ground pressure of a human foot, which can be 60 – 80 kPa while walking or as much as 13 MPa for a person in spike heels. [3] Increasing the size of the contact area on the ground (the footprint) in relation to the weight decreases the unit ground pressure.
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
Other units of pressure include: The bar (symbol: bar), defined as 100 kPa exactly. The atmosphere (symbol: atm), defined as 101.325 kPa exactly. These four pressure units are used in different settings. For example, the bar is used in meteorology to report atmospheric pressures. [7] The torr is used in high-vacuum physics and engineering. [8] [9]
Simple conversion factors (0.433 for specific gravity and 0.052 for ppg) convert these values to a pressure gradient in psi per foot. Multiplying by the depth in feet gives the pressure at the bottom of the column. Of course, when the well is being drilled in metres as the depth unit, the maths gets more complicated.