Search results
Results from the WOW.Com Content Network
The YZ125 has a 124 cc (7.6 cu in) reed valve-inducted two-stroke engine. It was air cooled from 1974 to 1980, and liquid cooled since 1981. It has a Mikuni 38 mm TMX series carburetor. [6] The engine produces 35 hp (26 kW). [1] The YZ125 has been built with five- or six-speed manual sequential gearbox depending on model year.
3 Third generation: (2019–2022) Toggle Third generation: (2019–2022) subsection. ... There is a small 2021 update, that adds a vapor canister to the fuel system, ...
YDS-3 (1964) 246 cc, two-stroke, parallel-twin, it used the world's first oil injection lubrication system in a 2-stroke engine. [2] DT-1 (1968) Yamaha's first true off-road motorcycle. [1] XS-1 (1970) Yamaha's first four-stroke engine motorcycle (650 cc twin). [3] YZ Monocross (1975) First production motocross bike with a single rear shock. [3]
Cars with gasoline direct injection (GDI) have been especially prone to carbon buildup, and car makers recommend fuels with higher detergent levels to combat the problem. [18] At first GDI was mainly available in high-end autos, but it is now being used in mid-range cars and economy cars, such as the Hyundai Sonata, Ford Focus and Hyundai Accent.
Yamaha entered the ATC market in 1980, after paying patent-right to Honda to produce their own version of the All Terrain Cycle. Starting modestly with a 125cc recreational ATC that would remain the foundation of their line through 1985, the YT125 featured a 2 stoke engine with sealed airbox with snorkel intake, an autolube oil injection system, and featured a narrow tunnel above the engine ...
The engine using this system, running at 8500 rpm, takes a very considerable 46 crank degrees before any signal from the cylinder can reach the runner end (assuming no movement of the air in the runner). 46 degrees, during which nothing but the volume of the port/runner supplies the demands of the cylinder. This not only applies to the initial ...
Typically, the system is operated by the pilot manually switching the intake air to travel via the heated intake path as required. The carburetor heat system reduces the power output (due to the lower density of heated air) and causes the intake air filter to be bypassed, therefore the system is only used when there is a risk of icing. [35]
A gas jet, fluid jet, or hydro jet is a nozzle intended to eject gas or fluid in a coherent stream into a surrounding medium. Gas jets are commonly found in gas stoves , ovens , or barbecues . Gas jets were commonly used for light before the development of electric light .