Ad
related to: lamp finial to attach switch to single step board for tile trim system
Search results
Results from the WOW.Com Content Network
Lamp harp with fluorescent bulb. A lamp harp is the component of a lamp to which the lamp shade is attached. It typically comes in two separate parts, a saddle which is fastened under the lamp socket, and the harp itself which consist of a lightweight frame attached to the saddle at its lower end and extending upwards to a point above the bulb ...
The Carter system, also known as the Chicago system, was a method of wiring three-way switches in the era of early knob-and-tube wiring. This now-obsolete wiring method has been prohibited by the USA National Electrical Code since 1923, [ 2 ] even in new knob-and-tube installations which are still permitted under certain circumstances.
Table lamp fixtures, standard lamp fixtures, and office task light luminaires. Balanced-arm lamp is a spot light with an adjustable arm such as anglepoise, RAMUN or Luxo L1. Gooseneck (fixture) Nightlight; Floor Lamp Torch lamp or torchières are floor lamps with an upward-facing shade. They provide general lighting to the rest of the room.
A key switch 3-way socket has the switch incorporated in the lamp socket and requires no external wiring between switch and socket. This would be typical in a 3-way floor-standing floor lamp. A 3-way socket that is to be wired to a separate 3-way 2-circuit switch, is called a keyless 3-way socket. [4]
The toggle light switch was invented in 1916 by William J. Newton. [2] As a component of an electrical wiring or home wiring system, the installation of light switches is regulated by some authority concerned with safety and standards. In different countries the standard dimensions of the wall mounting hardware (boxes, plates, etc.) may differ.
did not confine switching to the hot conductor (the so-called Carter system prohibited as of 1923 places electrical loads across the common terminals of a three-way switch pair) permitted the use of in-line splices in walls without a junction box (however, this downside is offset by the strong nature of the soldered and taped junctions used at ...
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
The U.S. National Electrical Code (NEC) defines a switchboard as "a large single panel, frame, or assembly of panels on which are mounted, on the face, back, or both, switches, over-current and other protective devices, buses, and usually instruments". [2]
Ad
related to: lamp finial to attach switch to single step board for tile trim system