Search results
Results from the WOW.Com Content Network
Inclusions are present in any steel to a greater or lesser extent according to the mixture and conditions of production. Usually the amount of non-metallic inclusions in steel is not higher than 0.1%. However, the number of inclusions in metal is very high because of their extremely small size. Non-metallic inclusions in steel are foreign ...
In C-Mn steel weld metals, it is reported that nucleation of various ferrite morphologies is aided by non-metallic inclusion; in particular oxygen-rich inclusions of a certain type and size are associated with the intragranular nucleation of acicular ferrite.
WEC initiation at MnS inclusions in steel [1] White etching cracks (WEC), or white structure flaking or brittle flaking, is a type of rolling contact fatigue (RCF) damage that can occur in bearing steels under certain conditions, such as hydrogen embrittlement, high stress, inadequate lubrication, and high temperature. WEC is characterised by ...
Note that decrease in carbon content increases the problems with non-metallic inclusions. [7] [needs update] Continuous casting and strip-casting technologies have largely superseded ingot casting techniques in recent times. Through these methods, all steel is killed and the resulting yields are close to 96%.
After polishing, certain microstructural constituents can be seen with the microscope, e.g., inclusions and nitrides. If the crystal structure is non-cubic (e.g., a metal with a hexagonal-closed packed crystal structure, such as Ti or Zr ) the microstructure can be revealed without etching using crossed polarized light (light microscopy).
Gas inclusion—gas entrapment within the solidified weld—manifests itself in a wide variety of defects, including porosity, blow holes, and pipes (or wormholes). Gas formation can be from any of the following causes—high sulphur content in the workpiece or electrode , excessive moisture from the electrode or workpiece, too short of an arc ...
Pearlite occurs at the eutectoid of the iron-carbon phase diagram (near the lower left). Pearlite is a two-phased , lamellar (or layered) structure composed of alternating layers of ferrite (87.5 wt%) and cementite (12.5 wt%) that occurs in some steels and cast irons .
Presently, CSST and FAC tubing both use corrugated stainless steel tubing. In the past, FAC used corrugated brass tubing. However, FAC tubing is made only in lengths of 1 to 6 feet, FAC tubing is made with connectors on each end, and FAC tubing does not have a plastic sheath. On FAC tubing the corrugations are visible.