Search results
Results from the WOW.Com Content Network
In the adjacent diagram, water pumped from the tower basin is the cooling water routed through the process coolers and condensers in an industrial facility. The cool water absorbs heat from the hot process streams which need to be cooled or condensed, and the absorbed heat warms the circulating water (C).
Canton Tower, Guangzhou, China Kobe Port Tower, Kobe, Japan Cooling tower, Puertollano, Spain. This page is a list of hyperboloid structures.These were first applied in architecture by Russian engineer Vladimir Shukhov (1853–1939).
Hence they are more commonly used in purpose-driven structures, such as water towers (to support a large mass), cooling towers, and aesthetic features. [3] A hyperbolic structure is beneficial for cooling towers. At the bottom, the widening of the tower provides a large area for installation of fill to promote thin film evaporative cooling of ...
Cooling towers are structures for cooling water or other heat transfer media to near-ambient wet-bulb temperature. Wet cooling towers operate on the evaporative cooling principle, but are optimized to cool the water rather than the air. Cooling towers can often be found on large buildings or on industrial sites.
Cooling tower and water discharge of a nuclear power plant. Water cooling is a method of heat removal from components and industrial equipment. Evaporative cooling using water is often more efficient than air cooling. Water is inexpensive and non-toxic; however, it can contain impurities and cause corrosion.
Specific spray pond surface areas tend to range between 1.2 and 1.7 m 2 per m 3 /h of water to be cooled. The width chosen for a drift channel around the active zone of the pond (containing the sprays) is dependent on a number of factors, including the prevailing wind strength, the average size of the spray droplets produced by the nozzles, and the presence of any nearby structures which may ...
The cooling towers of a large chilled water system. As part of a chilled water system, the condenser water absorbs heat from the refrigerant in the condenser barrel of the water chiller and is then sent via return lines to a cooling tower, which is a heat exchange device used to transfer waste heat to the atmosphere.
Windcatchers that cool by drawing air over water use the water as a heat reservoir, but if the air is dry, they are also cooling the air with evaporative cooling. [2] The heat in the air goes into evaporating some of the water, and will not be released until the water re-condenses. This is a very effective way of cooling dry air. [2]