Search results
Results from the WOW.Com Content Network
The TAG flash point tester adheres to ASTM D56 and has no stirrer, while the Abel flash point testers adheres to IP 170 and ISO 13736 and has a stirring motor so the sample is stirred during testing. The flash point is an empirical measurement rather than a fundamental physical parameter.
Those with flash points above 37.8 °C/100 °F and below 93.3 °C/200 °F were classified as combustible liquids. [ 2 ] [ 3 ] Studies show that the actual measure of a liquid's flammability, its flash point, is dependent on the local air pressure, meaning that at higher altitudes where the air pressure is lower, the flash point is also lower.
The Cleveland open-cup method is one of three main methods in chemistry for determining the flash point of a petroleum product using a Cleveland open-cup apparatus, also known as a Cleveland open-cup tester. [1] First, the test cup of the apparatus (usually brass) is filled to a certain level with a portion of the product.
Globally Harmonized System of Classification and Labelling of Chemicals uses a four category system to classify flammable liquids using flash point and boiling point temperature. [ 7 ] [ 8 ] This system is used internationally to evaluate and sort substances in industrial applications, workplaces and products distributed to consumers.
The flash point of kerosene is between 37 °C (99 °F) and 65 °C (149 °F), and its autoignition temperature is 220 °C (428 °F). [19] The freezing point of kerosene depends on grade, with commercial aviation fuel standardized at −47 °C (−53 °F). Grade 1-K kerosene freezes around −40 °C (−40 °F, 233 K). [20]
The flash evaporation of a single-component liquid is an isenthalpic process and is often referred to as an adiabatic flash. The following equation, derived from a simple heat balance around the throttling valve or device, is used to predict how much of a single-component liquid is vaporized.
The fire point, or combustion point, of a fuel is the lowest temperature at which the liquid fuel will continue to burn for at least five seconds after ignition by an open flame of standard dimension. [1] At the flash point, a lower temperature, a substance will ignite briefly, but vapour might not be produced at a rate to sustain the fire ...
Dimethyl sulfide is highly flammable; [35] its flash point is −38 °C (−36 °F) [36] or −49 °C (−56 °F). [37] Its self-ignition temperature is 205 °C (401 °F). [37] It is an eye and skin irritant and is harmful if swallowed. It has an unpleasant odor at even extremely low concentrations. [38]