Search results
Results from the WOW.Com Content Network
V PD: Maximum speed at which whole-aircraft parachute deployment has been demonstrated [42] V ra: Rough air speed (turbulence penetration speed). [9] V SL: Stall speed in a specific configuration [9] [39] V s 1g: Stall speed at 1g load factor [43] V sse: Safe single-engine speed [44] V t: Threshold speed [39] V TD: Touchdown speed [45] V TGT ...
The minimum control speed (V MC) of a multi-engine aircraft (specifically an airplane) is a V-speed that specifies the calibrated airspeed below which directional or lateral control of the aircraft can no longer be maintained, after the failure of one or more engines.
The initial 737-300 (foreground) is 9 ft 5 in (2.87 m) longer than the 737-200 (background) and is re-engined with wider and more efficient CFM56 turbofans. Following the success of the Boeing 737-200 Advanced, Boeing wanted to increase capacity and range, incorporating improvements to upgrade the plane to modern specifications, while also retaining commonality with previous 737 variants.
At a glance, the pilot can determine a recommended speed (V speeds) or if speed adjustments are needed. Single and multi-engine aircraft have common markings. For instance, the green arc indicates the normal operating range of the aircraft, from V S1 to V NO. The white arc indicates the flap operating range, V SO to V FE, used for approaches ...
The prototype -300, the 1,001st 737 built, first flew on February 24, 1984, with pilot Jim McRoberts. [57] It and two production aircraft flew a nine-month-long certification program. [58] The 737-300 retrofitted with Aviation Partners' winglets was designated the -300SP (Special Performance). The 737-300 was replaced by the 737-700 of the Next ...
V A is the design maneuvering speed and is a calibrated airspeed.Maneuvering speed cannot be slower than and need not be greater than V c. [4]If is chosen by the manufacturer to be exactly the aircraft will stall in a nose-up pitching maneuver before the structure is subjected to its limiting aerodynamic load.
II-5-1-3 Pilots may not use a lower category than the one certified, but may choose to use a higher category for higher speed approaches. [2] The maximum permitted speed for visual manoeuvring is significantly higher than the threshold speed. Additional speed ranges are specified for other segments of the approach. [1]: Table II-5-1-2
An aircraft's indicated airspeed in knots is typically abbreviated KIAS for "Knots-Indicated Air Speed" (vs. KCAS for calibrated airspeed and KTAS for true airspeed). The IAS is an important value for the pilot because it is the indicated speeds which are specified in the aircraft flight manual for such important performance values as the stall ...