Search results
Results from the WOW.Com Content Network
A typical soil is about 50% solids ... cations per unit weight of dry soil and is expressed in terms of ... grams dry weight of soil and whose measure is one ...
Saturated unit weight The unit weight of a soil when all void spaces of the soil are completely filled with water, with no air. The formula for saturated unit weight is: = (+) + where γ s is the saturated unit weight of the material; γ w is the unit weight of water; G s is the specific gravity of the solid; e is the void ratio [3] Submerged ...
Soil heat flux refers to the rate at which heat energy moves through the soil in response to a temperature difference between two points in the soil. The heat flux density is the amount of energy that flows through soil per unit area per unit time and has both magnitude and direction. For the simple case of conduction into or out of the soil in ...
The Unified Soil Classification System (USCS) is a soil classification system used in engineering and geology to describe the texture and grain size of a soil. The classification system can be applied to most unconsolidated materials, and is represented by a two-letter symbol. Each letter is described below (with the exception of Pt):
The bearing capacity of soil is the maximum average contact pressure between the foundation and the soil which should not produce shear failure in the soil. Ultimate bearing capacity is the theoretical maximum pressure which can be supported without failure; allowable bearing capacity is the ultimate bearing capacity divided by a factor of safety.
Specific surface area (SSA) is a property of solids defined as the total surface area (SA) of a material per unit mass, [1] (with units of m 2 /kg or m 2 /g). Alternatively, it may be defined as SA per solid or bulk volume [ 2 ] [ 3 ] (units of m 2 /m 3 or m −1 ).
At first, the dry unit weight after compaction increases as the moisture content (ω) increases, but after the optimum moisture content (ω opt) percentage is exceeded, any added water will result in a reduction in dry unit weight because the pore water pressure (pressure of water in-between each soil particle) will be pushing the soil ...
The bulk density of soil depends greatly on the mineral make up of soil and the degree of compaction. [3] The density of quartz is around 2.65 g/cm 3 but the (dry) bulk density of a mineral soil is normally about half that density, between 1.0 and 1.6 g/cm 3.