Search results
Results from the WOW.Com Content Network
Anchor capacity, or load resistance, should be considered for tensile loads (axial), sling angle (angular) and shear loads (transverse). Consideration of different load combinations may result in wide variations required from the lifting insert. The load directions during production, transport and placement should be considered carefully.
A sling, which may be made from ropes, is placed around the area that two legs meet to be used to put a tackle pulley system for lifting the load. There are two guy wires, front and rear, to support the shear legs. The rear guy may be reeved to allow adjustment of the angle of the shear legs. [7]
Sheer legs; Sling (rigging) – Rope, webbing, wire or chain used to support a load for lifting; Rope splicing – Semi-permanent joint between two ropes; Tackle – System of two or more pulleys and a rope or cable; Tirfor – Device for pulling cable; Tugger (rigging) Turnbuckle – Device for adjusting the tension or length of ropes or cables
Original file (Ogg multiplexed audio/video file, Theora/Vorbis, length 1 min 2 s, 1,280 × 720 pixels, 4.51 Mbps overall, file size: 33.54 MB) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
Lifting equipment can be assigned a Working Load Limit (WLL) in the interests of avoiding failure; Working Load Limit is calculated by dividing the Minimum Breaking Load of the equipment by a safety factor. [5] WLL as a concept is not restricted to lifting, being also relevant for mooring ropes. [6]
The hydraulic calculation procedure is defined in the applicable reference model codes such as that published by the US-based National Fire Protection Association (NFPA), [2] or the EN 12845 standard, Fixed firefighting system – Automatic sprinkler systems – Design, installation and maintenance.
The M-1956 load-carrying equipment (LCE), also known as the individual load-carrying equipment (ILCE), was developed by the U.S. Army and first issued in the early 1960s. [1] The M-1956 LCE was designed to replace the M-1945 Combat Pack, the M-1923 cartridge belt, the M-1936 pistol belt and the M-1937 BAR magazine belt. The M-1956 LCE was ...
A lifting hook is usually equipped with a safety latch to prevent the disengagement of the lifting wire rope sling, chain or rope to which the load is attached. A hook may have one or more built-in pulley sheaves as a block and tackle to multiply the lifting force. Lifting hook attached to sheave suspended by wire rope from boom of crane