Search results
Results from the WOW.Com Content Network
Roof shapes include flat (or shed), gabled, hipped, arched, domed, and a wide variety of other configurations detailed below. [1]Roof angles are an integral component of roof shape, and vary from almost flat to steeply pitched.
This template adds a table pre-formatted for listing road lengths. Please check this template's documentation; you must enter wikitext editing mode and add the rest of the table to complete the process of adding it. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status margin-right margin-right Right margin of the ...
Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);
This avoids details which require a great deal of work or cost and which are prone to damage. If the pitch or the rafter lengths of the two roof sections are different, it is described as an 'asymmetrical gable roof'. A gable roof on a church tower (gable tower) is usually called a 'cheese wedge roof' (Käsbissendach) in Switzerland.
Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.
Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
The common rafter connects the peak of a roof (the ridge) to the base of a roof (the plate). This number gives the length of the common rafter per twelve units of horizontal distance (run). Hip or valley rafter per foot of run. The hip or valley rafter also connects the ridge to the plate, but lies at a 45-degree angle to the common rafter ...
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.