enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A drain-waste-vent system (or DWV) is the combination of pipes and plumbing fittings that captures sewage and greywater within a structure and routes it toward a water treatment system. It includes venting to the exterior environment to prevent a vacuum from forming and impeding fixtures such as sinks, showers, and toilets from draining freely ...

3. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   A plug in sanitation is an object that is used to close a drainage outlet firmly. The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole. Plugs are most commonly encountered in the bathroom or kitchen ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Non-metallic gaskets are used with flat- or raised-face flanges. Spiral-wound gaskets are used with raised-face flanges, and ring-joint gaskets are used with ring-type joint (RTJ) flanges. Stress develops between an RTJ gasket and the flange groove when the gasket is bolted to a flange, leading to plastic deformation of the gasket. [4]

5. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, [36] although lead pipes were approved by national plumbing codes into the 1980s, [37] and lead was used in plumbing solder for drinking water until it was banned in 1986. [36] Drain and vent lines are made of plastic, steel, cast iron ...

6. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Also, the tortuous S-shaped path the water is forced to follow offers a significant obstruction to the flow. For high pressure domestic water systems this does not matter, but for low pressure systems where flow rate is important, such as a shower fed by a storage tank, a "stop tap" or, in engineering terms, a "gate valve" is preferred.

7. Drain (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Drain_(plumbing)

   Drain (plumbing) A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed. In most systems, the drain is for discharge of waste fluids, such as the drain in a sink in ...