Search results
Results from the WOW.Com Content Network
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
The corner of a chisel, knife, or gouge bevel which meets the back of the blade and polishes the cut. holdfast. Also called a hold down. A hold-down iron fitting into a hole in a bench and tightened or loosened by hammer taps. hollow grind A concave bevel on a chisel, gouge, or knife.
It covers the uneven edge of flooring next to the wall; protects the wall from kicks, abrasion, and furniture; and can serve as a decorative molding. [1] At its simplest, baseboard consists of a simple plank nailed, screwed or glued to the wall; however, particularly in older houses, it can be made up of a number of moldings for
There are several types of butt joint based on the orientation of the pieces being joined. These include the T-butt, end-to-end butt, Miter butt and edge-to-edge butt. The T-butt joint is a very simple joint to construct. Members are simply docked (cut off) at a right angle and at the required length.
When correctly placed, blocking also provides grounds (also backing or back blocking) for supporting the cut ends of wall claddings and linings or for attaching items such as cabinets, shelving, handrails, vanity tops and backsplashes, towel bars, decorative mouldings, etc. Properly placed grounds make the second fixings easier once the walls ...
Rotational molding offers design advantages over other molding processes. With proper design, parts assembled from several pieces can be molded as one part, eliminating high fabrication costs. The process also has inherent design strengths, such as consistent wall thickness and strong outside corners that are virtually stress-free.
Corner blocks are used to join the corners of a soft-cover flat. They are normally made of 1 ⁄ 4 -inch (6.4 mm) plywood, and are triangles with corners of 45°, 45°, and 90°. They are most often made by ripping the plywood at 6 + 1 ⁄ 2 inches (170 mm) and then mitering it at 45 degree angles to create triangles with 9-inch (230 mm) legs.
Coping is only ever used for internal corners. External corners are always mitred. The main reason that scribed joints are used is that timber shrinks in width far more than it does in length. By using a scribed joint rather than an internal mitre joint, the effect of shrinkage is minimised. Also it is possible to arrange the scribed joints ...