Search results
Results from the WOW.Com Content Network
APA – The Engineered Wood Association is the nonprofit trade association of the U.S. and Canadian engineered wood products industry. Based in Tacoma, Washington, the Association is composed of and represents manufacturers of structural plywood, oriented strand board (OSB), cross-laminated timber, glued laminated (glulam) timber, wood I-joists, laminated veneer lumber (LVL) and other ...
In 1971 "Micro=Lam LVL" was introduced. "Micro=Lam LVL" consisted of laminated veneer lumber billets 4 feet (1.2 m) wide, 3 + 1 ⁄ 2 inches (89 mm) thick, and 80 feet (24 m) long. Troutner proved the structural capabilities of his Micro=Lam product by building a house in Hagerman, Idaho, using beams made of Micro=Lam.
Typical U.S. height for panels is 8 or 9 feet (2.4 or 2.7 m). Panels come in widths ranging from 4 to 12 inches (100–300 mm) thick and a rough cost is $4–$6/ft 2 in the U.S. [5] In 4Q 2010, new methods of forming radius, sine curve, arches and tubular SIPs were commercialized. Due to the custom nature and technical difficulty of forming and ...
Plywood was introduced into the United States in 1865 [7] and industrial production there started shortly after. In 1928, the first standard-sized 4 ft by 8 ft (1.22 m by 2.44 m) plywood sheets were introduced in the United States for use as a general building material. [4]
Re-sawing is the splitting of 1-to-12-inch (25–305 mm) hardwood or softwood lumber into two or more thinner pieces of full-length boards. For example, splitting a 10-foot-long (3.0 m) 2×4 (1 + 1 ⁄ 2 by 3 + 1 ⁄ 2 in or 38 by 89 mm) into two 1×4s (3 ⁄ 4 by 3 + 1 ⁄ 2 in or 19 by 89 mm) of the same length is considered re-sawing.
The Janka hardness test results tabulated below followed ASTM D 1037-12 testing methods. Lumber stocks tested range from 1" to 2" (25–50 mm) thick. The tabulated Janka hardness numbers are an average. There is a standard deviation associated with each species, but these values are not given. [citation needed] No testing was done on actual ...
Medium density overlay panel, or MDO panel, is a paintable surface made of plywood with a weather-resistant resin overlay bonded to the wood by heat and pressure. The overlay, which has at least 27% resin content, [1] resists water, weather, wear and degradation. A similar product with a more rugged, smoother surface is called high density ...
Glulam brace with plates used for connections Glulam frame of a roof structure. Glued laminated timber, commonly referred to as glulam, is a type of structural engineered wood product constituted by layers of dimensional lumber bonded together with durable, moisture-resistant structural adhesives so that all of the grain runs parallel to the longitudinal axis.