Search results
Results from the WOW.Com Content Network
Elimination reaction of cyclohexanol to cyclohexene with sulfuric acid and heat [1] An elimination reaction is a type of organic reaction in which two substituents are removed from a molecule in either a one- or two-step mechanism. [2] The one-step mechanism is known as the E2 reaction, and the two-step mechanism is known as the E1 reaction ...
The order of reactivity, as shown by the vigour of the reaction with water or the speed at which the metal surface tarnishes in air, appears to be Cs > K > Na > Li > alkaline earth metals, i.e., alkali metals > alkaline earth metals, the same as the reverse order of the (gas-phase) ionization energies.
The rate of the overall reaction depends on the slowest step, so the overall reaction will be first order when the reaction of the energized reactant is slower than the collision step. The half-life is independent of the starting concentration and is given by t 1 / 2 = ln ( 2 ) k {\textstyle t_{1/2}={\frac {\ln {(2)}}{k}}} .
measurement of the effect of isotopic substitution on the reaction rate [9] for reactions in solution, measurement of the effect of pressure on the reaction rate to determine the volume change on formation of the activated complex [10] [11] for reactions of ions in solution, measurement of the effect of ionic strength on the reaction rate [12] [13]
The case for S N 2 reactions is quite different, as the lack of solvation on the nucleophile increases the rate of an S N 2 reaction. In either case (S N 1 or S N 2), the ability to either stabilize the transition state (S N 1) or destabilize the reactant starting material (S N 2) acts to decrease the ΔG ‡ activation and thereby increase the ...
For example, it is commonly asserted that the reactivity of alkali metals (Na, K, etc.) increases down the group in the periodic table, or that hydrogen's reactivity is evidenced by its reaction with oxygen. In fact, the rate of reaction of alkali metals (as evidenced by their reaction with water for example) is a function not only of position ...
The change in reactivity caused by a change of voids inside the reactor is directly proportional to the void coefficient. A positive void coefficient means that the reactivity increases as the void content inside the reactor increases due to increased boiling or loss of coolant; for example, if the coolant acts predominantly as neutron absorber.
This energy barrier is known as activation energy (∆G ≠) and the rate of reaction is dependent on the height of this barrier. A low energy barrier corresponds to a fast reaction and high energy barrier corresponds to a slow reaction. A reaction is in equilibrium when the rate of forward reaction is equal to the rate of reverse reaction.