enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

3. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Flange nut: Collar nut Has a wide flange at one end that acts as an integrated washer ... T-nut (lower), cap (or acorn), nylon locking (top and side views), and ...

4. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.

5. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   To simplify matters, the term hexagon is used in this section to denote either bolt head or nut. Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats ...

6. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   A regular computer case may require/include [5] 7 thumb screw 6-32 × 6 mm for 2.5” drive tray, expansion slots; 4 hexagon screw 6-32 × 6 mm for psu; 21 phillips screw 6-32 × 5 mm for motherboard, 3.5” harddisk tray; 12 phillips screw M3 × 5 mm for 2.5” harddrive; 16 KB5 x 10 mm for fans; 9 standoff 6-32 × 6.5 + 4 mm for motherboard

7. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fitting systems have three components that make a tubing assembly: fitting, flare nut, and sleeve. As with other flared connection systems, the seal is achieved through metal-to-metal contact between the finished surface of the fitting nose and the inside diameter of the flared tubing.