enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   Air admittance valves (AAVs, or commonly referred to in the UK as Durgo valves and in the US as Studor vents and Sure-Vent®) are negative-pressure-activated, one-way mechanical valves, used in a plumbing or drainage venting system to eliminate the need for conventional pipe venting and roof penetrations.

3. Hand pump - Wikipedia

   en.wikipedia.org/wiki/Hand_pump

   On the up stroke of the piston the foot valve opens and suction brings water into the pump head. On the following down stroke of the piston the valve on the piston opens up and allows water to flow above the piston. On the successive up stroke of the piston water is pushed out of the outlet. A rural handpump in Belgium.

4. Completion (oil and gas wells) - Wikipedia

   en.wikipedia.org/wiki/Completion_(oil_and_gas_wells)

   Gas lift well: gas is fed into valves installed in mandrels in the tubing strip. The hydrostatic head is lowered and the fluid is gas lifted to the surface. Single-well alternate completions: in this instance there is a well with two zones. In order to produce from both the zones are isolated with packers.

5. Downhole safety valve - Wikipedia

   en.wikipedia.org/wiki/Downhole_safety_valve

   This means that they are installed as a component of the completion string and run in during completion. Retrieving the valve, should it malfunction, requires a workover. The full name for this most common type of downhole safety valve is a Tubing Retrievable Surface Controlled Sub-Surface Valve, shortened in completion diagrams to TRSCSSV.

6. Well drainage - Wikipedia

   en.wikipedia.org/wiki/Well_drainage

   The well filter must be placed in a permeable soil layer. The spacing can be calculated with a well spacing equation using discharge, aquifer properties, well depth and optimal depth of the water table. The determination of the optimum depth of the water table is the realm of drainage research.

7. Tremie - Wikipedia

   en.wikipedia.org/wiki/Tremie

   Assembled tremie placing concrete underwater Hopper, pipes and lifting cap components of a tremie concrete placement tube. A tremie is a watertight pipe, usually of about 250 mm inside diameter (150 to 300 mm), [1] with a conical hopper at its upper end above the water level. It may have a loose plug or a valve at the bottom end.