Search results
Results from the WOW.Com Content Network
The hull of a submarine must be able to withstand the forces created by the outside water pressure being greater than the inside air pressure. The outside water pressure increases with depth and so the stresses on the hull also increase with depth. Each 10 metres (33 ft) of depth puts another atmosphere (1 bar, 14.7 psi, 101 kPa) of pressure on ...
Critical pressure of water 28 MPa 4,100 psi Overpressure caused by the bomb explosion during the Oklahoma City bombing [72] 40 MPa 5,800 psi Water pressure at the depth of the wreck of the Titanic: 69 MPa 10,000 psi Water pressure withstood by the DSV Shinkai 6500 in visiting ocean depths of > 6500 meters [73] 70 to 280 MPa 10,000 to 40,000 psi
The pressure of seawater at a depth of 33 feet equals one atmosphere. The absolute pressure at 33 feet depth in sea water is the sum of atmospheric and hydrostatic pressure for that depth, and is 66 fsw, or two atmospheres absolute. For every additional 33 feet of depth, another atmosphere of pressure accumulates. [6]
When there is no flow, the pore pressure at depth, h w, below the water surface is: [4] =, where: p s is the saturated pore water pressure (kPa) g w is the unit weight of water (kN/m 3), = / [5] h w is the depth below the water table (m),
The water table is the upper surface of the phreatic zone or zone of saturation. The zone of saturation is where the pores and fractures of the ground are saturated with groundwater, [1] which may be fresh, saline, or brackish, depending on the locality. It can also be simply explained as the depth below which the ground is saturated.
The onboard systems indicated a depth of 37,800 feet (11,521 m; 6,300 fathoms), [24] but this was later revised to 35,814 feet (10,916 m; 5,969 fathoms). [25] The depth was estimated from a conversion of pressure measured and calculations based on the water density from sea surface to seabed. [23]
Bathymetric charts showcase depth using a series of lines and points at equal intervals, called depth contours or isobaths (a type of contour line). A closed shape with increasingly smaller shapes inside of it can indicate an ocean trench or a seamount, or underwater mountain, depending on whether the depths increase or decrease going inward.
The first recorded evidence of water depth measurements are from Ancient Egypt over 3000 years ago. [3] Bathymetry has various uses including the production of bathymetric charts to guide vessels and identify underwater hazards, the study of marine life near the floor of water bodies , coastline analysis and ocean dynamics , including ...