Search results
Results from the WOW.Com Content Network
Two-stroke engines often have a higher power-to-weight ratio than a four-stroke engine, since their power stroke occurs twice as often. Two-stroke engines can also have fewer moving parts, and thus be cheaper to manufacture and weigh less. In countries and regions with stringent emissions regulation, two-stroke engines have been phased out in ...
The Detroit Diesel Series 110 is a two-stroke diesel engine series, available in straight-6 cylinder configuration (in keeping with the standard Detroit Diesel practice at the time, engines were referred to using a concatenation of the number of cylinders and the displacement, so this was a model 6-110).
The inline six-cylinder 71 series engine was introduced as the initial flagship product of the Detroit Diesel Engine Division of General Motors in 1938.. This engine was in high demand during WWII, necessitating a dramatic increase in output: about 57,000 6-71s were used on American landing craft, including 19,000 on LCVPs, about 8,000 on LCM Mk 3, and about 9,000 in quads on LCIs; and 39,000 ...
The Series 92 engines were introduced in 1974. [8] Compared to the Series 71 engines they were derived from, the Series 92 featured a larger bore of 4.84025 ± 0.00125 in (122.942 ± 0.032 mm) and an identical stroke of 5 in (130 mm) for a nominal displacement per cylinder of 92 cu in (1,510 cc), from which the Series 92 derives its name.
[note 1] The EMD 710 is a relatively large medium-speed two-stroke diesel engine that has 710 cubic inches (11.6 liters) displacement per cylinder, [1] and a maximum engine speed of 900 rpm. [note 2] In 1951, E. W. Kettering (son of Charles F. Kettering) wrote a paper for the ASME entitled, History and Development of the 567 Series General ...
Two-stroke engines used to be ubiquitous in dirt bike racing, thanks to their lightweight construction and horsepower. Packed in a dirt bike frame, they make a motorcycle playful in the corners ...
Cutaway model of a MAN B&W two-stroke marine diesel engine with the piston rod attached to a crosshead. In the two-stroke cycle, the four stages of internal combustion engine operation (intake, compression, ignition, exhaust) occur in one 360° revolution of the crank shaft, whereas in a four-stroke engine they take two complete revolutions.
The 12V-53 is a low-production / prototype engine consisting of two coupled 6V-53 engines; fewer than 20 were estimated to have been built, mostly for marine service in generator sets. One of the 6V-53 engines was a left-hand rotation and the other was right-hand rotation; they were coupled at their flywheels. [9]