enow.com Web Search

  1. Ads

    related to: foot valve for shallow well drain kit for water heater 50 gal

Search results

  1. Results from the WOW.Com Content Network
  2. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  3. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  4. Water heat recycling - Wikipedia

    en.wikipedia.org/wiki/Water_heat_recycling

    Installation of a double-walled copper-on-copper heat exchanger in a vertical section of the master drain line in a Canadian home (2007) Water heat recycling (also known as drain water heat recovery, waste water heat recovery, greywater heat recovery, [citation needed] or sometimes shower water heat recovery [citation needed]) is the use of a heat exchanger to recover energy and reuse heat ...

  5. Well drainage - Wikipedia

    en.wikipedia.org/wiki/Well_drainage

    The well filter must be placed in a permeable soil layer. The spacing can be calculated with a well spacing equation using discharge, aquifer properties, well depth and optimal depth of the water table. The determination of the optimum depth of the water table is the realm of drainage research.

  6. Downhole safety valve - Wikipedia

    en.wikipedia.org/wiki/Downhole_safety_valve

    This means that they are installed as a component of the completion string and run in during completion. Retrieving the valve, should it malfunction, requires a workover. The full name for this most common type of downhole safety valve is a Tubing Retrievable Surface Controlled Sub-Surface Valve, shortened in completion diagrams to TRSCSSV.

  7. Flow coefficient - Wikipedia

    en.wikipedia.org/wiki/Flow_coefficient

    A simplified version of the definition is: The k v factor of a valve indicates "The water flow in m 3 /h, at a pressure drop across the valve of 1 kgf/cm 2 when the valve is completely open. The complete definition also says that the flow medium must have a density of 1000 kg/m 3 and a kinematic viscosity of 10 −6 m 2 /s, e.g. water. [clarify]

  1. Ads

    related to: foot valve for shallow well drain kit for water heater 50 gal