Search results
Results from the WOW.Com Content Network
For instance, if estimating the effect of a drug on blood pressure with a 95% confidence interval that is six units wide, and the known standard deviation of blood pressure in the population is 15, the required sample size would be =, which would be rounded up to 97, since sample sizes must be integers and must meet or exceed the calculated ...
Bias in standard deviation for autocorrelated data. The figure shows the ratio of the estimated standard deviation to its known value (which can be calculated analytically for this digital filter), for several settings of α as a function of sample size n. Changing α alters the variance reduction ratio of the filter, which is known to be
The following expressions can be used to calculate the upper and lower ... will tend to approximate the population standard deviation as the sample size increases. ...
When only a sample of data from a population is available, the term standard deviation of the sample or sample standard deviation can refer to either the above-mentioned quantity as applied to those data, or to a modified quantity that is an unbiased estimate of the population standard deviation (the standard deviation of the entire population).
Most power and sample size calculations are heavily dependent on the standard deviation of the statistic of interest. If the estimate used is incorrect, the required sample size will also be wrong. One method to get an impression of the variation of the statistic is to use a small pilot sample and perform bootstrapping on it to get impression ...
Since the square root introduces bias, the terminology "uncorrected" and "corrected" is preferred for the standard deviation estimators: s n is the uncorrected sample standard deviation (i.e., without Bessel's correction) s is the corrected sample standard deviation (i.e., with Bessel's correction), which is less biased, but still biased
Algorithms for calculating variance play a major role in computational statistics.A key difficulty in the design of good algorithms for this problem is that formulas for the variance may involve sums of squares, which can lead to numerical instability as well as to arithmetic overflow when dealing with large values.
If ¯ and denote the sample mean and standard deviation of the log-transformed data for a sample of size n, a 95% confidence interval for is given by ¯, /, where , denotes the quantile of a t-distribution with degrees of freedom. It may also be of interest to derive a 95% upper confidence bound for the median air lead level.