Search results
Results from the WOW.Com Content Network
The gateway address (or default gateway) is a router interface connected to the local network that sends packets out of the local network. The gateway has a physical and a logical address. The gateway has a physical and a logical address.
If a router finds a match, it will forward the packet through that route; if not, it will send the packet to its own default gateway. Each router encountered on the way will store the packet ID and where it came from so that it can pass the response packet back to the sender. The packet contains source and destination, not all router hops.
The new Livebox has a pairing mode for Wi-Fi: Wifi Protected Setup (WPS). In December 2011 WPS was shown to be vulnerable to brute-force attacks, and should not be considered secure. The new router includes DLNA, so all the devices connected to the Livebox (via Ethernet or Wi-Fi) can share the contents of the USB disks connected to the Livebox.
If properly configured, the PC can also function as the router for a home LAN. An internal modem can be installed on a single PC (e.g. on a PCI card), also allowing that single PC to connect to a WAN. [7] Again, the PC can be configured to function as a router for a home LAN. A cellular wireless access point can function in a similar fashion to ...
Routers often incorporate a digital subscriber line modem or a cable modem and a Wi-Fi access point, are frequently set up in homes and other buildings, to provide Internet access for the structure. Similarly, battery-powered routers may include a mobile broadband modem and a Wi-Fi access point. When subscribed to a cellular data carrier, they ...
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...