Search results
Results from the WOW.Com Content Network
The density of quartz is around 2.65 g/cm 3 but the (dry) bulk density of a mineral soil is normally about half that density, between 1.0 and 1.6 g/cm 3. In contrast, soils rich in soil organic carbon and some friable clays tend to have lower bulk densities (<1.0 g/cm 3) due to a combination of the low-density of the organic materials ...
where is the void ratio, is the porosity, V V is the volume of void-space (gases and liquids), V S is the volume of solids, and V T is the total (or bulk) volume. This figure is relevant in composites , in mining (particular with regard to the properties of tailings ), and in soil science .
Elastic properties describe the reversible deformation (elastic response) of a material to an applied stress.They are a subset of the material properties that provide a quantitative description of the characteristics of a material, like its strength.
Filler materials are particles added to resin or binders (plastics, composites, concrete) that can improve specific properties, make the product cheaper, or a mixture of both. [1] The two largest segments for filler material use is elastomers and plastics . [ 2 ]
where is the volume fraction of the fibers in the composite (and is the volume fraction of the matrix).. If it is assumed that the composite material behaves as a linear-elastic material, i.e., abiding Hooke's law = for some elastic modulus of the composite and some strain of the composite , then equations 1 and 2 can be combined to give
It is also known as the stiffness to weight ratio or specific stiffness. ... high density, 10% compression [4] 1.3 ... Concrete (under compression) 40 ±10 2.4:
Polymer concrete is a type of concrete that uses a polymer to replace lime-type cements as a binder. One specific type is epoxy granite , where the polymer used is exclusively epoxy . In some cases the polymer is used in addition to portland cement to form Polymer Cement Concrete (PCC) or Polymer Modified Concrete (PMC). [ 1 ]
This is manufactured by dispersing long strands (usually >1”) of chopped fiber, commonly glass fibers or carbon fibers on a bath of thermoset resin (typically polyester resin, vinyl ester resin or epoxy resin). The longer fibers in SMC result in better strength properties than standard bulk moulding compound (BMC) products. Typical ...