Search results
Results from the WOW.Com Content Network
Accordingly, there are two variants of parity bits: even parity bit and odd parity bit. In the case of even parity, for a given set of bits, the bits whose value is 1 are counted. If that count is odd, the parity bit value is set to 1, making the total count of occurrences of 1s in the whole set (including the parity bit) an even number.
Parchive (a portmanteau of parity archive, and formally known as Parity Volume Set Specification [1] [2]) is an erasure code system that produces par files for checksum verification of data integrity, with the capability to perform data recovery operations that can repair or regenerate corrupted or missing data.
A parity bit is a bit that is added to a group of source bits to ensure that the number of set bits (i.e., bits with value 1) in the outcome is even or odd. It is a very simple scheme that can be used to detect single or any other odd number (i.e., three, five, etc.) of errors in the output.
The parity bit in each character can be set to one of the following: None (N) means that no parity bit is sent and the transmission is shortened. Odd (O) means that the parity bit is set so that the number of 1 bits is odd. Even (E) means that the parity bit is set so that the number of 1 bits is even.
The effect of a checksum algorithm that yields an n-bit checksum is to map each m-bit message to a corner of a larger hypercube, with dimension m + n. The 2 m + n corners of this hypercube represent all possible received messages. The valid received messages (those that have the correct checksum) comprise a smaller set, with only 2 m corners.
Logic parity RAM recalculates an always-valid parity bit each time a byte is read from memory, instead of storing the parity bit when the memory is written to; the calculated parity bit, which will not reveal if the data has been corrupted (hence the name "fake parity"), is presented to the parity-checking logic.
The data must be divided into transmission blocks, to which the additional check data is added. The term usually applies to a single parity bit per bit stream, calculated independently of all the other bit streams . [1] [2] This "extra" LRC word at the end of a block of data is very similar to checksum and cyclic redundancy check (CRC).
The parity bit may be used within another constituent code. In an example using the DVB-S2 rate 2/3 code the encoded block size is 64800 symbols (N=64800) with 43200 data bits (K=43200) and 21600 parity bits (M=21600). Each constituent code (check node) encodes 16 data bits except for the first parity bit which encodes 8 data bits.