Search results
Results from the WOW.Com Content Network
For best results, the breech must be opened at the proper time, just as the forward momentum of the gases reaches its maximum, the peak flow. This means that bore extractors are normally used only on guns with semi-automatic or fully automatic actions, where the breech is opened and the shell ejected as part of the recoil process.
The recoil operation is a type of locked-breech action used in semi-automatic and fully automatic firearms. It also uses energy from the combustion in the chamber acting directly on the bolt through the cartridge head, but in this case the firearm has a reciprocating barrel and breech assembly, combined with a bolt that locks to the breech.
A flip-up barrel and lack of extractor on a Beretta Bobcat semi-automatic pistol. Some very early blowback pistols used ammunition with no rim or extractor groove on the cartridge cases (e.g., 5mm Bergmann), and such pistols, therefore, lacked extractors.
If the ammunition is caseless, the time required to expel the previous case is removed from the cycle time of an automatic firearm and a higher rate of fire can be obtained than with normal ammunition. [1] The Heckler & Koch G11 Assault rifle uses caseless ammunition, but has a rotating breech, not a floating breech. However, the barrel, breech ...
Chambers of a revolver's cylinder. The act of chambering a cartridge means the insertion of a round into the chamber, either manually or through the action of the weapon, e.g., pump-action, lever-action, bolt action, or autoloading operation generally in anticipation of firing the weapon, without need to "load" the weapon upon decision to use it (reducing the number of actions needed to ...
A lapping process known as "fire lapping" uses a lead "slug" that is slightly larger than the bore and covered in fine abrasive compound to cut out the constrictions. The slug is passed from breech to muzzle to remove obstructions. Many passes are made, and as the bore becomes more uniform, finer grades of abrasive compound are used.
A metal cup on the front of the block, together with the pressure of the screw behind it, provided "obturation" and sealed the breech to prevent escape of gasses rearward on firing. The sliding-block was known as the "vent-piece", as the vent tube was inserted through it to fire the gun. In modern terms it was a vertical sliding-block.
The Model 1861 used metal rimfire cartridges and had a laterally hinged block called the "cap" which enveloped the standing breech and could be swung open to the left when the locking catch was released. This design was refined in 1862 with the addition of cam surfaces which improved the cartridge seating and extraction. [1]