Search results
Results from the WOW.Com Content Network
A patch antenna is a narrowband, wide-beam antenna fabricated by etching the antenna element pattern in metal trace bonded to an insulating dielectric substrate, such as a printed circuit board, with a continuous metal layer bonded to the opposite side of the substrate which forms a ground plane. Common microstrip antenna shapes are square ...
An antenna like effect is achieved by periodic swing of electrons from its capacitive element to the ground plane which behaves like an inductor. The authors further argued that the operation of a dielectric antenna resembles the antenna conceived by Marconi, the only difference is that inductive element is replaced by the dielectric material. [5]
Stubs are commonly used in antenna impedance matching circuits, frequency selective filters, and resonant circuits for UHF electronic oscillators and RF amplifiers. Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide.
Cross-section of microstrip geometry. Conductor (A) is separated from ground plane (D) by dielectric substrate (C). Upper dielectric (B) is typically air. Microstrip is a type of electrical transmission line which can be fabricated with any technology where a conductor is separated from a ground plane by a dielectric layer known
The category of simple antennas consists of dipoles, monopoles, and loop antennas. Nearly all can be made with a single segment of wire (ignoring the break made in the wire for the feedline connection). [citation needed] Dipoles and monopoles called linear antennas (or straight wire antennas) since their radiating parts lie along a single ...
A microstrip hairpin filter followed by a low pass stub filter on a PCB in a 20GHz Agilent N9344C spectrum analyser. For other (non-printed) technologies, short-circuit lines may be preferred since the short-circuit provides a mechanical attachment point for the line and Q-reducing dielectric insulators are not required for mechanical support ...
A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane. It is the original type of microstrip antenna described by Howell in 1972. [1]
The prior art includes an RF MEMS frequency tunable fractal antenna for the 0.1–6 GHz frequency range, [18] and the actual integration of RF MEMS switches on a self-similar Sierpinski gasket antenna to increase its number of resonant frequencies, extending its range to 8 GHz, 14 GHz and 25 GHz, [19] [20] an RF MEMS radiation pattern ...