Search results
Results from the WOW.Com Content Network
A vapor barrier (or vapour barrier) is any material used for damp proofing, typically a plastic or foil sheet, that resists diffusion of moisture through the wall, floor, ceiling, or roof assemblies of buildings and of packaging to prevent interstitial condensation.
Rising damp is the effect of water rising from the ground into property. [3] The damp proof course may be horizontal or vertical. [4] A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material
Damp proofing: This is waterproofing used where the water table is lower than the structure and there is good free-draining fill. The membrane deals with the shedding of water and the ingress of water vapor only, with no hydrostatic pressure. Generally, this incorporates a damp proof membrane (DPM) to the walls with a polythene DPM under the ...
The purpose of a Vertical Damp Proof Barrier is to prevent the ingress of damp and water into subterranean structures such as basements, cellars, tunnels and earth shielded buildings. (Also known as Earth sheltered buildings ).
Butyl rubber sealant is used for damp proofing, rubber roof repair and for maintenance of roof membranes (especially around the edges). It is important [ citation needed ] to have the roof membrane fixed, as a lot of fixtures (e.g., air conditioner vents, plumbing, and other pipes) can considerably loosen it.
In earlier days, birch bark was occasionally used as a flashing material. [7] Most flashing materials today are metal, plastic, rubber, or impregnated paper. [8]Metal flashing materials include lead, aluminium, copper, [1] stainless steel, zinc alloy, other architectural metals or a metal with a coating such as galvanized steel, lead-coated copper, anodized aluminium, terne-coated copper ...
While structural damp-proofing and waterproofing to prevent decay was a motive of the Truscon laboratories chemicals, the side benefit was that it provided better hygienic conditions. [ 3 ] Some of the products developed for damp-proofing was Por-Seal, Stone-Tex, Stone-Backing, and Plaster Bond. [ 4 ]
For example, bitumen could also be used for flooring, damp proofing in buildings, and for waterproofing of various types of pools and baths, both of which were also proliferating in the 19th century. [ 3 ] [ 44 ] [ 62 ] One of the earliest surviving examples of its use can be seen at Highgate Cemetery where it was used in 1839 to seal the roof ...