Search results
Results from the WOW.Com Content Network
At the time that the 10 Gigabit Ethernet standard was developed, interest in 10GbE as a wide area network (WAN) transport led to the introduction of a WAN PHY for 10GbE. The WAN PHY was designed to interoperate with OC-192/STM-64 SDH/SONET equipment using a light-weight SDH/SONET frame running at 9.953 Gbit/s.
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of Institute of Electrical and Electronics Engineers (IEEE).
1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and Cat 6).
The Category 7 cable standard was ratified in 2002, and primarily introduced to support 10 gigabit Ethernet over 100 m of copper cabling. [2] It contains four twisted copper wire pairs, just like the earlier standards, terminated either with GG45 electrical connectors or with TERA connectors rated for transmission frequencies of up to 600 MHz. [3]
10 Gigabit Ethernet is a version of Ethernet with a nominal data rate of 10 Gbit/s, ten times as fast as Gigabit Ethernet. The first 10 Gigabit Ethernet standard, IEEE Std 802.3ae-2002, was published in 2002. Subsequent standards encompass media types for single-mode fiber (long haul), multi-mode fiber (up to 400 m), copper backplane (up to 1 m ...
Direct-Attach Copper (DAC) is a type of standard cabling used in Small Form-factor Pluggable (SFP) Ethernet, initially defined with SFP+ Direct-Attach Copper (10GSFP+Cu), which provides 10 Gigabit Ethernet over either an active or passive twinax cable assembly and connects directly into an SFP+ housing. An active twinax cable has active ...
10 gigabit media-independent interface (XGMII) is a standard defined in IEEE 802.3 designed for connecting full duplex 10 Gigabit Ethernet (10GbE) ports to each other and to other electronic devices on a printed circuit board (PCB). It is now typically used for on-chip connections. PCB connections are now mostly accomplished with XAUI.
10 Gigabit Attachment Unit Interface (XAUI / ˈ z aʊ i / ZOW-ee) is a standard for extending the XGMII (10 Gigabit Media Independent Interface) between the MAC and PHY layer of 10 Gigabit Ethernet (10GbE) defined in Clause 47 of the IEEE 802.3 standard.