Search results
Results from the WOW.Com Content Network
The Lockheed P-80 Shooting Star is the first jet fighter used operationally by the United States Army Air Forces (USAAF) during World War II. [1] Designed and built by Lockheed in 1943 and delivered just 143 days from the start of design, two pre-production models saw limited service in Italy just before the end of World War II.
A spare part, spare, service part, repair part, or replacement part, is an interchangeable part that is kept in an inventory and used for the repair or refurbishment of defective equipment/units. Spare parts are an important feature of logistics engineering and supply chain management , often comprising dedicated spare parts management systems.
The first commercially successful mechanical seal to be used on centrifugal pumps was probably made by the Cameron Division of the Ingersoll-Rand Company. The Cameron seal was installed in a number of centrifugal pipeline pumps in 1928. [6] Mechanical seals in the 1930s often used a face combination of hardened steel versus leaded bronze.
A hydrodynamic seal is a type of mechanical seal. A hydrodynamic seal uses a dynamic rotor with grooves that act as a pump and create an air film that the opposing sealing surface will ride on. A hydrodynamic seal performs better than hydrostatic seals by providing greater film stiffness, lower leakage and lower lift off speeds.
A static hydraulic seal is located in a groove and sees no movement - only sealing within its confined space, acting like a gasket. To achieve this the gasket should be under pressure. The pressure is applied by tightening of the bolts. Examples of static seals include O-rings, flange seals, and cover seals. Dynamic
The effectiveness of a seal is dependent on adhesion in the case of sealants and compression in the case of gaskets. The seals are installed in pumps in a wide range of industries including chemicals, water supply, paper production, food processing and many other applications. [1] A stationary seal may also be referred to as a 'packing'. Seal ...
The power needed from the drive is proportional to the pressure and capacity of the pump. [1] Seals are an integral part of piston pumps and plunger pumps to separate the power fluid from the medium that is being pumped. A stuffing box or packing is used to seal the joint between the vessel where the medium is transferred and the plunger or ...
Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...