Search results
Results from the WOW.Com Content Network
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
The General Motors Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydra-Matic introduced in the autumn of 1939 as a (very likely subsidized) $57 option for the 1940 Oldsmobile. [1]
The second overdrive is with ring 2 braked which will cause sun 2 to spin faster than in the first overdrive gear. There is one reverse gear. Ring 1 and ring 3 are braked with the input only connected to sun 1. Sun 1 will drive ring 2 in the forward direction and with carrier 2 braked, sun 2 and sun 3 will spin in reverse.
1st Gear Ratio 3.55:1 2nd Gear Ratio 2.16:1 3rd Gear Ratio 1.48:1 4th Gear Ratio 1.13:1 5th Gear Ratio 0.89:1 Reverse Gear Ratio 3.33:1 Final Drive Ratio 3.55:1. 3.42:1 or 3.72:1 found in 4WD F20's. There are two types of flywheel, depending on the manufacturing year. Kadetts had "Flat" flywheels, which are lighter, while Astras, Vectras and ...
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
The "MN4" 4T40E is able to handle vehicles up to 4000 lb (1814 kg) GVWR. The final drive ratio can vary depending on the car's curb weight and engine power output. 3.91, 3.63, 3.29, 3.05, 3.69, and 3.42 are all of the available ratios used in the 4T40 (and 4T45) transmission; Made possible by using combinations selected from 3 different sprocket combinations (32/38, 35/35, 33/37) and 2 ...
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.