enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [18]: 61 [19] In addition, a well-designed system will often use two 45° elbows instead of one 90° elbow (even a sweep 90° elbow) to reduce flow disruption as much as possible. [18]: 61 Central vacuum system inlet fittings are intentionally designed with a tighter curvature radius than other bends in the system.

4. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   All DWV systems require various sized fittings and pipes which are measured by their internal diameter of both the pipes and the fittings which, and in most cases are Schedule 40 PVC wye's, tee's, elbows ranging from 90 degrees to 22.5 degrees for both inside diameter fitment (street) as well as outer diameter fitment (hub), repair and slip ...

5. Structural pipe fitting - Wikipedia

   en.wikipedia.org/wiki/Structural_pipe_fitting

   The project can be disassembled and stored if needed, or even taken apart with fittings and pipe recycled into a new project. Fittings used for strong structures are galvanised malleable iron castings, and come in many styles such as elbows, tees, crosses, reducers and flanges. The fittings are not threaded; they simply lock onto the pipe with ...

6. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

7. Jimmie Walker - Wikipedia

   en.wikipedia.org/wiki/Jimmie_Walker

   Walker was born in Brooklyn, New York and raised in the Bronx. [3] He attended Theodore Roosevelt High School in New York City.Through a New York State funded program known as SEEK (Search for Education, Evaluation, and Knowledge), he continued his studies and entered into the field of radio engineering with WRVR.